Tuesday, July 5, 2022
Home Authors Posts by Hakan

Hakan

248 POSTS 1 COMMENTS

Mitsubishi CNC | M60-M70-M80 Series | Spindle Orientation Parameters

Introduction In case of encountering orientation problem, the parameters needed to overcome the problem are as follows. Spindle orientation parameters are different depend on controller...

Mitsubishi CNC | M70-M700 Series | Easy SSS Function

Introduction EasySSS control is used in high speed and high accuracy modes. Improved speed and speed control is achieved with this function. Increases the smoothness...

Mitsubishi CNC Milling | A Parameter | Linear Angle

A Code Introduction The end point coordinates are automatically calculated by commanding the linear angle and one of the end point coordinate axes. A Code Format N1...

Mitsubishi CNC Milling | R Parameter | Corner Rounding

R Code Introduction Chamfering at any angle or corner rounding is performed automatically by adding ",C_" or ",R_" to the end of the block to...

Mitsubishi CNC Milling | C Parameter | Corner Chamfering

C Code Introduction Chamfering at any angle or corner rounding is performed automatically by adding ",C_" or ",R_" to the end of the block to...

Mitsubishi CNC Milling | G33 Code | Constant Lead Thread Cutting

G33 Code Introduction The G33 code exercises feed control over the tool which is synchronized with the spindle rotation and so this makes it possible...

Mitsubishi CNC | M70-M80 Series | M01 Tap Retract Error and Solution

Tap Retract Function Introduction One standard feature of Mitsubishi M70 and M700 controls is a user-friendly Tap retract feature. After a manual interruption, in case...

Mitsubishi CNC | M60-M70 Series | External Encoder and Linear Scale Cancel

Introduction External encoders and linear scales are provided by various companies. Certain service / maintenance controls can be done via Mitsubishi CNC unit, but not...

Mitsubishi CNC | M70-M80 Series | Drive System and Axis Removal

Introduction This article is intended to disable one or more axes on a multi-axis machine with M70/M700/M80/M800 series. The main purpose is to teach how axes...

CNC Milling | Pocket Machining Program Example

Technical Drawing CNC Program Main Program (Cutting Diameter = 10mm.) N05 G55 N10 M6 T4 H4 G43 M3 N15 S1500 F120 N20 G0 X9 Y9 Z1 N25 G1 Z0 N30 M98 P030050 N35 G0...
error: Content is protected !!