The main purpose of the vertical axis fall prevention function. Undesirable situations such as plunge into the piece surface.
This is a standard feature in drive/control system and allow the vertical axis to be controlled by parameters. According to the setting the axis automatically moves in reverse direction in the event of power failure.
|#2233 bit E: 1 Turns the function on and off. If bit E = 0, function deactivated.|
For example, 0000 is passive, 4000 is active.
|#2232 TOF: Torque Offset parameter, By a load calculated according to the load of the axis in idle state.|
According to current load on “Drive monitor” screen, this parameter may be entered as (-) or (+).
|#2248 EMGrt: Vertical Axis Fall Prevention Time: Standard for HF motors 200 ms.|
|#2295: Vertical axis retraction distance 0-2000 micrometer range adjustable.|
Note: This procedure can be applied not only to vertical axes but also to all axes include horizontal axes.
|#2232 TOF parameter is normally 0|
#2232 = 1, axis moves in (+) direction
#2232 = -1, axis moves in (-) direction]]>